2015r3 TCS CDP pro PCB v8 v6 v5 v3

What’s the difference of TCS CDP PCB v3.0 v5.0 v6.0 v8.0 and how much do you know? Read the thread.

Now, it’s v8 pcb of TCS CDP +
v5 not work on nissan qashqai 2012 1.6 dci
v8 work well : v8 it’s better

  

There are two kinds of v8 pcb:

V8 PCB with a high-quality Bluetooth module:

Source: http://www.obdexpress.co.uk/wholesale/tcs-cdp-pro-diagnostic-bluetooth-a.html

V8 PCB with a normal Bluetooth module:

Source: http://www.obdexpress.co.uk/wholesale/tcs-cdp-pro-diagnostic-bluetooth-b.html

it’s v6 PCB but same like v5

TCS CDP v5.0 PCB with zener diodes 30v

V5.0 PCB original vs. copy:original v5.0 (2x fake 9241A=lm393 installed, KL only, not KKL) needs 5v zeners installed, if removed KL line stop working.
Original v5.0

V5.0 copy

New 5.0 pcb vs. Old 5.0 pcb

removing or replacing d701 and d703 diodes in this new 5.0 pcb version

new 5.0 is supposed to work ok without modifying the zener diodes
because pcb is completely different to previous versions and diodes are supposed to work as they should

Previous v5

New v5

It was v5 became v3

Amazing !
How these two will fit “pin to pin” it’s a mystery for me. Unless your PCB board is a completely redesigned version.

Pcb V5.0 vs. Pcb V3.0

with v3.0, 5v zeners must be just removed, or replaced with 30v zeners for trucks support
if modded v5.0 by robertdz is exactly = v3.0, again 5v zeners must be removed or replaced with 30v zeners.

different tracks and design

in case v5.0 pcb was designed for lm393, pins 6 and 7 would shorted on both left and right ic’s

Edit: tracks of 9241 on the right are all dead, no sense to replace it with another lm393, just the one on the left

NOTE: TCS CDP+ buying guide:

2014.R3 TCS CDP without Bluetooth

2015R3 TCSCDP Pro+ with Bluetooth

2015R3 TCS CDP+ PRO without Bluetooth

(New Design) 2015.3 TCSCDP Pro+ OBD2 scanner without Bluetooth

(New design) 2015.R3 TCSCDP Pro with Bluetooth and 4G Memory Card

http://obd2-diag.blogspot.com/2016/01/multidiag-pro-20153-20143-20141-20133.html